MTI DAGE-MTI IR-1000 Manual de usuario

User’s Manual DAGE-MTI IR-1000 IR CCD Camera

Gating The IR-1000 camera system can be externally gated in order to increase the sensitivity. Inhibiting the readout of the CCD's image allows

To inhibit the readout of the CCD, simply ground the center pin on the GATE connector. The camera will readout the two fields immediately following

Electronic Shutter The IR-1000 camera system can be shuttered in order to decrease the sensitivity. If electronic shuttering is desired, turn the SHU

Connector Pin-outs Power This 5-pin ‘DIN’ connector receives DC power from the external switching power supply. The supply plugs into an appropria

Camera This 12-pin ‘Hirose’ connector supplies all of the power and interface to the camera head. There are no user level connections recommended int

Specifications: Pick-up Device: 1/2" Interline CCD w/microlens Signal to Noise: 56db Shading: <5% overall Sensitivity: .05 fc (0.5 lu

020406080100400 500 600 700 800 900 1000 1100Wave Length (nm)Relative Response % Figure 7: IR-1000 Spectral Sensitivity

Troubleshooting No Picture (Check or try the following): 1. Camera Power On? a. External Power Supply Attached? b. AC Power On? c. LED on Control Uni

Warranty The DAGE-MTI IR-1000 is warranted to be free of defects in material and workmanship in normal use for a period of one year from the origina

Limitations 1. This warranty is valid only if the malfunctioning unit is returned to DAGE-MTI service depot. This warranty does not cover on-location

Purchaser’s Record Model Name: DAGE-MTI IR-1000 Serial Number: Dealer’s Name: Dealer’s Address: Dealer’s Phone Number:

DAGE-MTI Inc. 701 N. Roeske Ave. Michigan City, IN 46360 (219) 872-5514 Fax: (219) 872-5559 E-mail: [email protected] http://www.dagemti.com

Introduction The DAGE-MTI IR-1000 camera system is based upon a 1/2" Interline CCD that produces high-resolution imaging into the near IR spectr

Installation The IR-1000 camera head connects directly into the control unit. Power for the control is supplied by an external switching supply that

MONITORIR-1000VIDCAMERAPOWERPOWERSUPPLYHEADPOWERCORDGATECOMPUTERINVESTIGATERCONTROLUNIT1GATEVID INVID OUT23CCDCAMERACONTROLIR-1000 1. IR-1000 VID OUT

Figure 2: IR-1000 Control Rear Panel Power Connect the external switching supply to the rear panel's POWER connector and to a suitable power

Video This ‘BNC’ connector supplies video output of the IR-1000 system. The signal is 1Vp-p terminated into 75:. Be careful to avoid double termina

Operation Figure 3: IR-1000 Control Front Panel Power This switch controls the power to the IR-1000. The green light indicates when the power is o

Black Level The black level output is determined by this control. When set to MAX, the output video resides on a standard 50mV black pedestal. The